EPSON STYLUS PRO 4000
ERROR CODES AND MAINTENANCE MODE
MAINTENANCE ERRORS
Maintenance mode
Confirm
the printer is turned off first. While pressing and holding the Pause button,
press the Power button to turn on the printer.
Press the Menu button to enter the selected item. The first parameter is
displayed on the LCD.
Press the Paper Feed UP or Paper Feed DOWN button to select a parameter for the
item.
Press the Menu button to store the selected parameter. ,If the parameter is for
execution only, press the Menu ,button to execute the function for the item.
Note:If second parameter is displayed on the LCD, repeat
the steps 4 and 5 to
select and set the second parameter.
Press the Power button to turn off the printer, and turn it on again.
MAINTENANCE ERRORS
MAINTENANCE REQ
0002
CR movement cycles has reached predetermined value
MAINTENANCE REQ 0008
RTC backup battery shut off
MAINTENANCE REQ
0040
Pump counter has reached predetermined amount.
MAINTENANCE REQ 0080
Date is not set
MAINTENANCE REQ 0088
RTC backup battery is not installed.
MAINTENANCE REQ
0100
RTC backup battery pressure is temporally low.
MAINTENANCE REQ
0200
ASF paper feeding has reached predetermined value.
SERVICE ERRORS
SERVICE REQ
00000101
CR Motor life
SERVICE REQ
00010000
PF Motor Encoder check error
SERVICE REQ
00010001
PF Motor out of step
SERVICE REQ
00010002
PF Motor over current
SERVICE REQ
00010003
PF Motor inposition timeout
SERVICE REQ
00010004
CR Motor Encoder check error
SERVICE REQ
00010005
CR Motor out of step
SERVICE REQ
00010006
CR Motor over current
SERVICE REQ
00010007
CR Motor inposition timeout
SERVICE REQ
00010008
Servo interrupt watchdog timeout
SERVICE REQ 00010009
System interrupt watchdog timeout
SERVICE REQ 0001000A
CR axis detection
error
SERVICE REQ
0001000C
PG axis detection error
SERVICE REQ
0001000F
CR Motor PWM output faulty
SERVICE REQ
00010010
PF Motor PWM output faulty
SERVICE REQ
0001001B
Head driver (TG) temperature error
Maintenance mode
1.
Enters the maintenance mode
Confirm the printer is turned off first. While pressing and holding the Pause button, press the Power button to turn on the printer.
Confirm the printer is turned off first. While pressing and holding the Pause button, press the Power button to turn on the printer.
2.
Select an item
Press the Paper Feed UP or Paper Feed DOWN button to select
a desired item.
3. Set
the item
Press the Menu button to enter the selected item. The first parameter is displayed on the LCD.
Press the Menu button to enter the selected item. The first parameter is displayed on the LCD.
4. Select a parameter
Press the Paper Feed UP or Paper Feed DOWN button to select a parameter for the item.
Press the Paper Feed UP or Paper Feed DOWN button to select a parameter for the item.
5. Set the parameter
Press the Menu button to store the selected parameter. ,If the parameter is for execution only, press the Menu ,button to execute the function for the item.
Press the Menu button to store the selected parameter. ,If the parameter is for execution only, press the Menu ,button to execute the function for the item.
Note:If second parameter is displayed on the LCD, repeat
the steps 4 and 5 to
select and set the second parameter.
6. Exit the maintenance mode
Press the Power button to turn off the printer, and turn it on again.
Press the Power button to turn off the printer, and turn it on again.
