SONY KDL-40V3000 - KDL-46V3000 SERVICE MODE AND POWER SUPPLY CIRCUIT

SONY KDL-40V3000 - KDL-46V3000 

LCD TV 

SERVICE MODE AND POWER SUPPLY CIRCUIT 

Diagnostic Indicators
When an error occurs, the STANDBY LED fl ashes a set number of times to indicate the possible cause of the problem. If there is more than one error, the LED will identify the fi rst of the problem areas. If the errors occur simultaneously, the one that corresponds to the fewest fl ashes is identified first. (Results for all of the following diagnostic items are displayed on screen. No error has occurred if the screen displays a “00”)
1. TV must be in standby mode. (Power off).
2. Press the following buttons on the Remote Commander within a second of each other:
DISPLAY > Channel 5 > Volume - > TV POWER .
ACCESSING SERVICE ADJUSTMENTS
To adjust various set features, use the Remote Commander to put the set into service mode to display the service menus.
1. TV must be in standby mode. (Power off).
2. Press the following buttons on the Remote Commander within a second of each other:
DISPLAY > Channel 5 > Volume + > TV POWER .
The first service menu (TV) displays.
3. To display the service menu that contains the category you want to adjust, press JUMP on the Remote Commander.
The screen displays the first category in the selected service menu. The screen displays the first category in the selected service menu.
4. To change the category, press 2 or 5 on the Remote Commander.
Note: Pressing 2 or 5 only changes the categories within the service menu displayed. To change a category on one of the other service menus, press the JUMP button until the correct service menu is displayed.
5. To change the adjustment item, press 1 or 4 on the Remote Commander.
6. To change the data value, press 3 or 6 on the Remote Commander.
7. To write into memory, press MUTING then 0 on the Remote Commander.
8. To exit service mode, turn the power off.
UPDATING MODEL INFORMATION AFTER REPLACING THE FB1 BOARD
Complete the following steps to reset the model information to the correct size after replacing the FB1 Board.
1. Access the Service Menu by pressing the following buttons on the Remote Commander within a second:
DISPLAY > Channel 5 > Volume + > TV POWER .
The service menu displays.
2. Press the JUMP button until the BEM micro service menu displays.
3. Press 2 until the 0001 MODEL_INFO category displays.
4. Using the 3 or 6 on the remote commander to increase or decrease the value, do one of the following:
If model size is 40” Set to 0
If model size is 46” Set to 1
5. To write into memory, press MUTING then 0 on the Remote Commander.
8. To exit service mode, turn the power off.
POWER SUPPLY CIRCUIT 
CLICK ON THE IMAGE TO ZOOM IN